Kfs 598a operating procedures, Kfs 598a – BendixKing KXP 756 User Manual
Page 4
3
ACTIVE WINDOW
STANDBY WINDOW
ON/OFF/VOL
CHAN BUTTON
PHOTOCELL
TRANSFER BUTTON
FREQUENCY
CONTROL KNOBS
COMM
VOL
OFF
S
B
Y
CHAN
118.00
136.97
ı
PULL
TEST
the tuning knobs, and then trans-
ferring the selected frequency into the
Active window by pressing the
Transfer button. The larger tuning
knob will increase or decrease the
MHz portion of the display in 1 MHz
steps. At band edge (118 MHz on the
low end and either 136 or 151 MHz on
the high end) the next 1 MHz step will
cause the display to wrap around to
the opposite band edge. The smaller
tuning knob will increase or decrease
the KHz portion of the display in 50
KHz steps with the knob pushed in or
in 25 KHz steps with the knob pulled
out. Rollover to the opposite band
edge occurs at 000 and 975 KHz.
While in the Standby Entry mode, the
transceiver remains tuned to the
frequency displayed in the Active
window at all times. During the
transmit operation, a TX annunciation
will light just right of the active display,
signifying that the transceiver is in the
Transmit mode of operation.
KFS 598A Operating
Procedures
Rotate the VOL control knob
clockwise from the OFF position. A
momentary unsquelched state will
occur. To override the automatic
squelch state, push the PUSH TST
knob. To return to the squelched state
push the PUSH TST knob once again.
When the mic is keyed, the TX
annunciator will light just right of the
active display. If the mike key is held
down for more than 1-1/2 minutes, the
key line to the KTR 908 will be
disabled. The total display will then
flash as long as the mic key is
depressed.
Frequency Mode:
Standby Entry
Frequency selection is accomp-
lished in the Standby Entry mode by
changing the frequency displayed in
the Standby window of the display with
KFS 598A Control Functions