BendixKing KXP 756 - Manual (Page 9)

8
Civil Operation
Channel Mode
Momentarily pressing the CHAN
button while in the Frequency mode
will place the unit in the Channel
mode. The receiver will remain tuned
to the last Active frequency displayed
before entering the Channel mode.
The last Channel number used will be
displayed, unless no channels have
been programmed, in which case the
unit defaults to Channel 1 and dashes
are displayed in the Standby window.
Turning either Frequency Control
knob will increase or decrease the
Channel number. The unit will only
increase or decrease to channels that
have been programmed. The
frequency associated with each
Channel number will be displayed in
the Standby window. If there is no
knob activity for 5 seconds the unit will
return to the Frequency mode and the
Channel frequency will be displayed in
the Standby window. Pressing the
CHAN button will return the unit to the
Frequency mode and the status of the
Frequency mode prior to entering the
Channel mode will remain the same.
When in the Channel mode, pres-
sing the Transfer button will return the
unit to the Frequency mode. The
Channel frequency will become the
new Active frequency and the last
frequency used will be the new
Standby frequency. If the unit was in
the Active Entry mode prior to entering
the Channel mode, pressing the
Transfer button or allowing the unit to
time out will bring the unit back to the
Standby Entry mode.
Program Mode
The Program mode is entered by
pressing and holding the CHAN button
for more than 2 seconds. The receiver
remains tuned to the last Active
frequency displayed before entering
the Program mode and the last
Channel number used will be
displayed. The Channel number will
be flashing and may be changed with
the Frequency Control knobs.
Pressing the Transfer button will
cause the Channel number to stop
flashing and cause the frequency to
flash (unless the channel is Program
Secured). The frequency may then be
changed with the Frequency Control
knobs in the same manner as
described above with the exception
that the first step past any band edge
will cause dashes to be displayed.
Any Channel with dashes displayed
will be unprogrammed. Pressing the
Transfer button will cause the
frequency displayed to stop flashing
and the Channel number will flash
allowing the next channel to be
programmed.
The unit will revert to the
Frequency mode if no knob activity
takes place for 20 seconds. The unit
may also be returned to the Frequency
mode from the Program mode by
momentarily pressing the CHAN
button. On reentering the Frequency
mode the Active and Standby
frequencies displayed will be the last
frequencies displayed prior to entering
the Program mode.
Remote Transfer
Operates identically to the front
panel Transfer button with the
exception that holding the Remote
Transfer button for 2 seconds does not
cause the unit to enter the Active Entry
mode.