BendixKing KXP 756 User Manual
Page 36
35
Programming
The nineteen user channels are
programmed as follows:
1. Select the channel to be
programmed.
2. Step the cursor to the frequency
digits, and change them to the
desired receiver frequency.
Changing the displayed frequency
of a programable channel will
automatically place the control
head in program mode, as shown
by the flashing dash adjacent to
the channel number.
3. Press STO. When the radio
accepts the program of the receive
frequency, the flashing “TX” letters
will appear in the upper right of the
display and the cursor will move to
the 10/1MHz digits.
4. Change the displayed frequency to
the desired transmit frequency.
5. Press STO. When the transmit
frequency is accepted, the letters
“TX” will disappear as will the
cursor.
STO
The STO button performs three
functions. First, when in the channel
mode and not in program mode
(program mode is annunciated by a
flashing dash in the space adjacent to
the channel number), pressing STO
causes the head to display the letters
“TX” and the transmit frequency, while
the receiver monitors the transmit
frequency. This allows the user to
listen for signals on the transmit
frequency of a duplex channel.
Second, if STO is pushed while the
microphone is keyed, a 1000Hz tone
will transmitted. This is used to break
the squelch of some stations. Third,
pressing the STO while in program
mode enters the selected frequency
into the channel to be programmed.