CANOGA PERKINS 9145E10G Network Interface Device Hardware - Manual (Page 23)

Functional Description 9145E10G Ethernet Network Interface Device User’s Manual
LED Indicators
11
2.7 LED Indicators
The following paragraphs describe the functions of the LED indicators (see Figure 2-9) on the
9145E10G base unit.
Figure 2-8. LED Indicators
2.7.1 Management Section LEDs
Table 2-3 provides the indications supplied by the L/A, SPD, POWER and STATUS LEDs,
located to the right of the Ethernet Management and Console ports.
Table 2-3. LED Indicators
LED Name State Condition
L/A
Off
No link
No transmit or receive activity
Green Link on with full duplex
Blinking Green Transmission or receiving activity with full duplex
Amber
System Booting
Link on with half duplex
Blinking Amber Transmission or receiving activity with half duplex
SPD
Off Port Disabled
Green 10GBASE full
Amber System Test
Red Remote Fault
Blinking Red Invalid/Unsupported XFP installed
Slow Blinking Green* Port Enabled but No Link
LINK/ACTIVITY LED
SPEED LED
POWER LED
STATUS LED
LINK/ACTIVITY LED
SPEED LED
SPEED LED (-527 ONLY)
LINK/ACTIVITY LED (-527 ONLY)