CANOGA PERKINS 9145E10G Network Interface Device Hardware User Manual
Page 30
9145E10G Ethernet Network Interface Device User’s Manual
Installation
Mounting Options
18
Mounting One 9145E10G in a 19" or 23" Rack - To rack mount one 9145E10G, perform
the following steps:
1. Install the 19" Single Unit or 23" Single Unit Rack Mount Bracket Kit. The Rack Mount Kit
includes two mounting brackets, and the screws required to attach the brackets to the
9145E10G. The brackets attach to the two threaded holes on each side of the 9145E10G,
toward the front (see Figure 3-3) using the flat head screws provided. Torque the flat head
screws to 14.5 – 15.5 in-lb.
Figure 3-3. Install Rack Mount Kit
2. Place unit with brackets attached in place on the mounting rack.
3. Install two screws through each bracket into the threaded holes on the mounting rack
(see Figure 3-4). Torque the screws to the rack manufacturer’s specifications.
Figure 3-4. Mounting 9145E10G on Rack