CANOGA PERKINS 9145E10G Network Interface Device Hardware - Manual (Page 34)

9145E10G Ethernet Network Interface Device User’s Manual Installation
Installing the SFP and XFP Modules
22
3.4 Installing the SFP and XFP Modules
1. Determine which SFP and XFP Module(s) is/are required for the User, Network, and Mul-
tipurpose ports by referencing the Product Data Sheet.
2. Insert a module into each available port and push firmly to seat module (see Figure 3-10).
3. Raise latch to lock module in place.
Figure 3-10. Install SFP and XFP Modules
3.5 Connecting the Electrical Power
NOTE: When power is applied, all LED indicators will light amber.
3.5.1 AC Power
NOTE: Country specific power cords are available locally for installations
outside of North America
The 9145E10G uses a standard IEC320 AC Power Connector. Plug the AC power cord into the
socket at the rear of the 9145E10G and plug the other end of the AC power cord into a conve-
nient AC outlet.