CANOGA PERKINS 9145E10G Network Interface Device Hardware - Manual (Page 40)

9145E10G Ethernet Network Interface Device User’s Manual Operation
Power-Up and Front Panel Functions
28
panel LED, located directly below the L/A LED, indicates the speed of the transmissions. See
Table 4-1 to determine the 9145E10G status.
Table 4-1. Power, Status, and Ethernet Management LED Indications
LED Name State Condition
POWER
Off Power is off
Green Power is on
Red
One of the board supply voltages has exceeded a
threshold value
STATUS
Off No Power
Green Normal operation
Amber System self-test in progress
Blinking Amber System is booting
Red
One of the board supply voltages has exceeded a
threshold value
L/A
Off
No link
No transmit or receive activity
Green Link on with full duplex
Blinking Green Transmission or receiving activity with full duplex
Amber
System Booting
Link on with half duplex
Blinking Amber Transmission or receiving activity with half duplex
SPD
Off Port Disabled
Green 10GBASE full
Amber System Test
Red Remote Fault
Blinking Red Invalid/Unsupported XFP installed
Slow Blinking Green* Port Enabled but No Link
* Slow Blinking Green means LED toggles between OFF and GREEN approximately once per
second.