2 xfp, sfp and utp port status leds – CANOGA PERKINS 9145E10G Network Interface Device Hardware User Manual
Page 41
Operation
9145E10G Ethernet Network Interface Device User’s Manual
Power-Up and Front Panel Functions
29
4.1.2 XFP, SFP and UTP Port Status LEDS
The Speed (SPD) and Link/Activity (L/A) LEDs are located above the XFP, SFP and UTP Ports of
each port section (see Figure 4-1). See Table 4-2 to determine the current condition of these
ports.
Table 4-2. User and Network Port LED Indicators
LED Name
State
Condition
SPD
Off
Port Disabled
Green
10GBase Full
Amber
System Test
Red
Remote Fault
Blinking Red
Invalid/Unsupported XFP installed
Slow Blinking Green*
Port Enabled but No Link
L/A
Off
No link
No transmit or receive activity
Green
Link on with full duplex
Blinking Green
Transmission or receiving activity with full duplex
Amber
System test
Red
Port Disabled
LLF
Blinking Red
No Link, but transmitting OAM packets in unidirectional mode
* Slow Blinking Green means the LED toggles between OFF and GREEN approximately once per
second.