CANOGA PERKINS 9145EMP Network Interface Device Hardware - Manual (Page 20)

9145EMP Network Interface Device Hardware User’s Manual Functional Description
Service Data Ports
8
2.2.2 Rear Panel
Customers will also have a selection of power options to choose from (Figure 2-2). Five options
are offered:
1. Single AC Power
2. Redundant AC Power
3. Single DC Power
4. Redundant DC Power
5. Redundant AC and DC mix
Figure 2-2 9145EMP Rear Panel
The 9145EMP accommodates all five power options.
2.3 Service Data Ports
The User Ports (Figure 2-1) provide both fixed UTP and SFP connectors, while the Network
Ports provide SFP connectors. The user can configure the 9145EMP through software to allow
for either the UTP or SFP connector within each User Port to be active. Both User Port connec-
tors can not be active simultaneously.
• UTP connectors are IEEE 802.3 compliant for 10/100/1000BASE-T.
• UTP connectors support MDI and MDIX connections.
• UTP connectors support both full-duplex and half-duplex operation in 10/100/1000 Mbps
mode.
• SFP connectors support full-duplex operation at 100/1000 Mbps.