CANOGA PERKINS 9145EMP Network Interface Device Hardware - Manual (Page 29)

Installation 9145EMP Network Interface Device Hardware User’s Manual
9145EMP Installation Procedures
17
3.1 9145EMP Installation Procedures
This section describes how to unpack, install, and set up the 9145EMP. Before setting up the
9145EMP, make sure a 9 pin EIA-232 cable is available to connect the 9145EMP's console port
to a VT100 type terminal or PC for setup and configuration.
Keep the shipping container and all packing materials until the unit is installed and fully opera-
tional. In the event that the unit needs to be returned, contact Canoga Perkins Customer Service
for a Return Authorization Number (RMA) and instructions for return shipment.
CAUTION: Follow electrostatic discharge (ESD) safety precautions when
handling Canoga Perkins products, as with all electronic devices
with static sensitive components.
3.2 Unpacking
Open the shipping container, remove the accessories tray, and remove the accessories from the
tray (Figure 3-1). Lift the 9145EMP out of the shipping container and remove the foam end caps
from the unit. Return all packing materials to the shipping container and put it in a safe place in
the event the unit needs to be returned.
Chapter 3
Installation