CANOGA PERKINS 9145EMP Network Interface Device Hardware User Manual
Page 36
9145EMP Network Interface Device Hardware User’s Manual
Installation
Installing the SFP Modules
24
3.4 Installing the SFP Modules
1. Determine which SFP Module(s) is/are required for the User and Network Ports by refer-
encing the SFP Product Data Sheet.
2. Insert a module into each available port and push firmly to seat module (Figure 3-10).
3. Raise latch to lock module in place.
Figure 3-10 SFP Modules
3.5 Connecting the Electrical Power
NOTE: When power is applied, all LED indicators will light amber.
3.5.1 AC Power
NOTE: Country specific power cords are available locally for installations outside
of North America.
The 9145EMP uses a standard IEC320 AC Power Connector. Plug the AC power cord into the
socket at the rear of the 9145EMP and plug the other end of the AC power cord into a convenient
AC outlet.