CANOGA PERKINS 9145EMP Network Interface Device Hardware - Manual (Page 41)

Operation 9145EMP Network Interface Device Hardware User’s Manual
Power-Up and Front Panel Functions
29
4.1 Power-Up and Front Panel Functions
The LEDs on the front panel indicate the system and port status of the 9145EMP (Figure 4-1).
During power-up, all LEDs on the 9145EMP will light amber. When power-up has been com-
pleted, the LEDs will display status as described in the following paragraphs. Additional informa-
tion about fault conditions appears in the System Alarms and System Status and Configuration
screens (see the 9145EMP NID Software User’s Manual).
Figure 4-1 9145EMP Status Indicators
4.1.1 Power and Status LEDs
The power and status LEDs, located to the right of the console port (Figure 4-1), indicate condi-
tion and state of the 9145EMP.
Table 2-4 describes the significance of LED conditions. Table 2-5 describes the LED indicators
for the SPD and ACT LEDs of User Ports. Table 2-6 describes the LED indicators for Network
Ports.
POWER LED
STATUS LED
SPD LED
LNK/ACT LED
LNK/ACT LED SPD LED
SPD LED
USER PORT
USER PORT
NETWORK PORT
NETWORK PORT
LNK/ACT LED
MGMT UTP
PORT
CONSOLE
PORT
Chapter 4
Operation