CANOGA PERKINS 9145EMP Network Interface Device Hardware - Manual (Page 33)

Installation 9145EMP Network Interface Device Hardware User’s Manual
Mounting Options
21
Mounting Two 9145EMPs, Side by Side, in a 19" or 23" Rack - To rack mount two
9145EMPs, perform the following steps:
1. Install the 19" Dual Unit or 23" Dual Unit Rack Mount Bracket Kit. The Rack Mount Kit
includes two rack mount brackets, two center brackets, a strap, a rear bracket, and the
screws required to attach the brackets to the 9145EMPs. The mounting brackets attach to
the two threaded holes on the outside of each 9145EMP, toward the front (Figure 3-3).
The two center brackets attach to the two threaded holes on the inside of each 9145EMP,
and the strap mounts over the front of each center bracket (Figure 3-5). The rear center
bracket is attached to the threaded holes at the top inside corner of the back of each
9145EMP (Figure 3-6).
2. Place unit with brackets attached in place on the desired mounting rack.
3. Install two screws through each bracket into the threaded holes of the mounting rack (Fig-
ure 3-7). Torque the screws to the rack manufacturer’s specifications.
Figure 3-7 Mounting Two 9145EMPs on Rack
Figure 3-5 Install Center Brackets and Strap Figure 3-6 Install Rear Center Bracket
USER PO
RT
LINK/
ACT
SPD
RESET
POW ER
STATUS
9145EM
P