Leica Geosystems Leica DISTO plus - Manual - Manual (Page 10)

9 1st Function level Leica DISTO™ plus 1.0.0 GB
de
GB
fr
it
es
nl
ja
)
With each of the distance measurements you
can use:
•
a simple distance measurement,
• a value from stack/ mermory or
• a measurement with time delay release.
)
For short distances, a good base behind the
instrument is sufficient for mechanical alignment.
)
You will obtain the best results if the Leica
DISTO™ plus is rotated around a fixed point (rear edge,
thread position) and the axis of the laser beam passes
through this axis. The Leica DISTO™ plus should not be
placed on a camera tripod without an adapter, as the axis
of the laser beam would be 70 to 100 mm above the instru-
ment’s axis of rotation. Without the adapter this would lead
to significant height deviations in the measurements.
Determination with two points
For estimating the height/
width of buildings. Very
useful for making measure-
ments from standing position
(no bending) if the height is
determined with two or three
distances.
Press until
appears on the display; laser is activated and "1
---" starts blinking.
Aim at the upper point (1).
Trigger measurement; do not move the
instrument!
Value is accepted.
appears on the display and "2 ---" starts blinking.
Point the Leica DISTO™ plus approximately horizontal (2).
Press, a continuous measurement is triggered.
Move the Leica DISTO™ plus a large amount around the
ideal measurement point.
Stop of continuous measurement. The height
and width are displayed from measurements
(Pythagoras).
Detemination with 3 points
Press until
appears on the display; laser is activated and "1
---" starts blinking.
Aim at the upper point (1).
Trigger measurement; do not move the
instrument!
Value is accepted.
appears on the display and "2 ---" starts blinking.
Point the Leica DISTO™ plus approximately horizontal (2).
Press, a continuous measurement is triggered.