Leica Geosystems Leica DISTO plus - Manual - Manual (Page 9)

8 1st Function level Leica DISTO™ plus 1.0.0 GB
de
GB
fr
it
es
nl
ja
Determine maximum dimension, e.g. to determine the
(room) diagonal.
Press until
appears on the display.
Move the Leica DISTO™ plus a large amount around the
target point.
Activate continuous measurement with a brief
press.
Slowly rotate the Leica DISTO™ plus to the right/ left past
the corner.
Stop continuous measurement.
The largest measurement is displayed (e.g. 12.314m =
diagonal of room).
Calculations
Partial heights, partial distances
Make measurement.
Add by [ + ] key/ Subtract by[ - ] key.
Make additional measurements.
= Result.
)
In the same way chain values (= any amount of
distance measurements) and sums of areas/ volumes can
be added up.
)
During calculations "Clear" is available as long
as the function has not been executed!
Multiplication
Make measurement (e.g. 8.375m).
Multiplication by pressing [ x ] key.
Additional measurements (e.g. 8.375m).
= Area (e.g. 29.313m²)
)
The volume can be calculated by an additional
multiplication following an area calculation.
This function can be used for calculating areas or volumes
with individual partial heights/ partial distances.
Doubling a measured value
It is easy to double the measured values, e.g. to determine
the length of walls in a room:
Make measurement.
Add by [ + ] key.
Make additional measurements.
= Sum (=half circumference)
With key [ + ] repeat, double measured value.
= Sum (=circumference)
D5-Z13
Pythagoras, height/ width measure-
ment
)
The measuring sequence must be adhered to in
any case!
)
All three (two) points must be on a vertical or
horizontal line in the plane of the wall!