Leica Geosystems Leica DISTO plus - Manual - Manual (Page 7)

6 1st Function level Leica DISTO™ plus 1.0.0 GB
de
GB
fr
it
es
nl
ja
Confirm selection, reset to Normal Mode.
)
"Clear Entry" may also be used (e.g. to cancel a
selection).
Selecting units (menu)
Selectable units:
Measure with offset (menu)
D5-Z10
Call up menu point.
blinks on the display.
With key [+ / -] set desired offset (=shifting reference) (e.g.
0,015m); quick set by keeping key pressed.
For larger steps hold additionally.
)
Offset can be positive (add) or negative
(reduce)!
Confirm setting.
Is displayed continuously if offset
≠
0.
)
Subject to set offset, the measured results are
displayed.
Using this function you can measure with rough size, as an
example!
Please make this a rule: After rough size measurement
always set the Leica DISTO™ plus to offset 0.000: Call up
function as described
Press.
Confirm function.
)
After making/changing settings, it is imperative
that a test measurement is performed.
Resetting (menu)
Call up menu point.
starts blinking on the display.
With key [+ / -] select components to be reset. To choose
from:
Stack/ Mermory
Stack and Constant
If additional symbols e.g. units are shown in the display,
the following values are reset:
–
Offset (=0), Beep (On) and Units (meter)
Selected components are reset; back to
Measuring Mode.
Save values (constants)
Measure/ calculate desired value (e.g. height of room,
area, volume).
Press longer.
– m (mm) = 0.000 m – 14’ 06’’ 1/16 = ’ ’’ 1 /
16
– m (cm) = 0.00 m – in = 0.0 in
– ft = 0.00 ft – in 1/16 = 0 1 /
16 in
– ft in 1/16 = 0.00 1 /
16
ft in