Leica Geosystems Leica DISTO plus - Manual - Manual (Page 15)

14 Message Codes Leica DISTO™ plus 1.0.0 GB
de
GB
fr
it
es
nl
ja
* Maximum deviation occurs under unfavorable condi-
tions, such as in bright sunlight or when measuring to
inadequately reflecting surfaces. For distances over
30m-without using a target plate- themaximum devia-
tion may increase by ±0.1mm/m to maximum ±
10mm. For more information, refer to www.disto.com.
** As of 100m the measuring units are displayed in cm.
*** Reduced when using the BLUETOOTH
® function
Message Codes
Error message
appears beside the message number on the
display.
Please call your local dealership and specify the
message code. Should the message continue to
appear after several starts, then the instrument
is defective.
Care
Look after the optical surfaces with the same care that you
would apply to spectacles, cameras and field glasses.
The most current information can be found on our
homepage:
www.disto.com
We publish the addresses of specialized software
mannufacturers . However, we are not responsible for the
correctness of their specifications or for the performance
of their software.
For software developers, the Leica DISTO™ plus Online-
Interface description is available.
All illustrations, descriptions and technical specifica-
tions are subject to change without prior notice.
Message
Code
Cause Remedy
203 Wrong sequence with
Pythagoras meas.
Carry out measurement in
correct sequence
204 Calculation error Repeat procedure
240 Transmission error Repeat procedure
252 Temperature too high,
above 50°C (measuring)
Cool down instrument
253 Temperature too low,
below -10°C (measuring)
Warm up instrument
255 Receiver signal too weak,
measurement time too
long, distance <200 mm
Use target plate
measurement time >10
sec.
256 Received signal too
powerful
Use target plate (correct
side)
257 Wrong measurement,
ambient brightness too
high
Use target plate
260 Laser beam interrupted Repeat measurement
All other messages Call service "System"
Message
Code
Cause Remedy