Leica Geosystems Leica DISTO plus - Manual - Manual (Page 6)

5 1st Function level Leica DISTO™ plus 1.0.0 GB
de
GB
fr
it
es
nl
ja
Time delay release
Instrument must be in Pointing Mode.
Press and hold until desired time delay has been
reached (max. 60 seconds).
appears on the display.
Once the key is released, the remaining seconds (e.g. 59,
58, 57...) are displayed, until measuring.
The last 5 seconds are counted down with a "beep".
After the last "beep", the measurement is made and the
value displayed.
Example: Measuring without any key activation.
D5-Z8
Calculations
Area
Press until
appears on the display.
The side to be measured blinks.
Make 2 measurements (l x w).
The result and the two partial results appear on the
display.
Volume
Press until
appears on the display.
The side to be measured blinks.
Make 3 measurements (l x w x h).
The result and the three partial results appear on the
display.
Menu/ Settings
The menus allow a free selection of the settings that are to
remain valid after switching off the instrument. The
functions follow each other endlessly (rollmode).
Press to toggle between the functions.
D5-Z9
4 Measure with offset (add/reduce)
5 Selecting measuring units
6 Beep
7 Reset
Menü aufrufen:
Press until desired menu point appears or with
key [+ / -] switch between the various menu
points.
Confirm selection, activate menu point.
or with key [+ / -] change setting as desired.