Leica Geosystems Leica DISTO plus - Manual - Manual (Page 11)

10 2nd Function level Leica DISTO™ plus 1.0.0 GB
de
GB
fr
it
es
nl
ja
Move the Leica DISTO™ plus a large amount around the
ideal measurement point.
Stop of continuous measurement.
Value is accepted and and on the display "3 ---" starts
blinking.
Aim at the lower point (3).
Trigger measurement; do not move the
instrument!
The height and width are displayed from three
measurements (Pythagoras).
Determination of a partial height with 3
points
Height determination between
point 1 and point 2 with three
measured points.
Press until
appears on the display; laser is activated and
"1 ---" starts blinking.
Aim at the upper point (1).
Trigger measurement; do not move the
instrument!
Value is accepted and on the display "2 ---" starts blinking.
Trigger measurement; do not move the
instrument!
Value is accepted.
appears on the display and "3 ---" starts blinking.
Press, a continuous measurement is triggered.
Move the Leica DISTO™ plus a large amount around the
ideal measurement point.
Stop of continuous measurement. The height
and width are displayed between point 1 and 2
(Pythagoras).
2 nd Function level
)
Only in the second level can measured values
be transferred or corrected with the Leica DISTO™ plus.
The type and number of functions that can be activated in
the second function level depend on the software used.
Switching on the BLUETOOTH ®
Press briefly.
If BLUETOOTH ® is switched on, this icon
appears in the display.
The data connection must be built up by the application
software on a Pocket PC or PC. As long as the connection
is being built up, this icon will be blinking.
)
If during 120 seconds after switching on the
BLUETOOTH ® no connection is established with the
Pocket PC or PC, then the BLUETOOTH ® is switched off
automatically.
If five minutes after the connection has been established,
no data transfer has occurred, then the BLUETOOTH
® is
switched off automatically. After a further 90 seconds, the
Leica DISTO™ plus is also switched off.