Compaq 326817-003 - Manual (Page 21)

Installation 2-3
Compaq Confidential – Need to Know Required
Writer: Debbie McRill Project: Compaq DAT AutoLoader Reference Guide Comments:
Part Number: 326817-003 File Name: c-ch2 Installation.doc Last Saved On: 1/25/00 10:01 AM
Setting the SCSI ID
Each SCSI device on the same SCSI bus must have a unique SCSI ID. Use the
jumper block located on the back of the DAT AutoLoader to set the SCSI ID.
For SCSI ID jumper settings see Table 2-2.
Table 2-2
SCSI Jumper Pins
SCSI ID Bit 2 Bit 1 Bit 0
0 0 0 0
1 0 0 1
2 0 1 0
3 0 1 1
4 1 0 0
5 1 0 1
6 1 1 0
7* 1 1 1
Note: SCSI ID 7 is reserved for the SCSI controller.
Switch Settings
When the DAT AutoLoader is powered on, it reads a set of configuration
switches on the underside of the drive. See the following sections for switch
descriptions and settings.