Compaq 326817-003 - Manual (Page 30)

3-2 Compaq DAT AutoLoader Reference Guide
Compaq Confidential – Need to Know Required
Writer: Debbie McRill Project: Compaq DAT AutoLoader Reference Guide Comments:
Part Number: 326817-021 File Name: d-ch3 Installing Software Drivers.doc Last Saved On: 1/25/00 10:06 AM
Microsoft Windows NT
Drivers for the SCSI controllers and tape drive hardware are located on
Support Software Diskettes and on the Compaq SmartStart and Support
Software CD. The Support Software ships with each computer or can be
downloaded from the Compaq website. The software tape device driver is
located either with your tape backup software or with the operating system.
Refer to your backup application installation guide for more information
regarding additional software that might be needed
.
Table 3-1
Microsoft Windows NT
Controller Software Driver Information
■ 32-Bit Fast SCSI-2 Controllers
■ 32-Bit Fast-Wide SCSI-2 Controllers
■ Wide-Ultra SCSI Controllers
■ LVD Wide SCSI Controllers
Refer to "Compaq SCSI Controller Support" in
the NTREADME.HLP file on the Compaq
Support Software for Microsoft Windows NT
diskette, Version 1.21 or later.
IMPORTANT: If the SCSI controller to which your drive is attached was not present during
your initial Windows NT installation, install the SCSI device driver for the controller before
installing the tape class driver.
Refer to “Compaq Tape Support” in the NTREADME.HLP file on the Compaq
Support Software for Microsoft Windows NT diskette.