Compaq 326817-003 - Manual (Page 25)

Installation 2-7
Compaq Confidential – Need to Know Required
Writer: Debbie McRill Project: Compaq DAT AutoLoader Reference Guide Comments:
Part Number: 326817-003 File Name: c-ch2 Installation.doc Last Saved On: 1/25/00 10:01 AM
2. Connect the SCSI signal cable and the power cable (supplied).
(See Figure 2-5.)
3. Carefully slide the DAT AutoLoader the remainder of the way in,
adjusting the connecting cables if needed to allow the AutoLoader to be
fully inserted.
4. Insert two screws in the front plate using a Torx-15 screwdriver.
To install the Autoloader without drive rails:
1. Remove all screws from drive rails using a Torx-15 screwdriver.
2. Slide the AutoLoader partially into an available removable media bay.
Figure 2-4. Installing the DAT AutoLoader without drive rails
3. Connect the SCSI signal cable and the power cable (supplied).
(See Figure 2-5.)
4. Carefully slide the DAT AutoLoader the remainder of the way in,
adjusting the connecting cables if needed to allow the AutoLoader to be
fully inserted.
5. Use the screws that were removed from the drive rails and insert two of
them into the threaded mounting holes on each side.
NOTE: Some drives may not be accessible on both sides. Secure the sides that are
accessible.