Before reqyestnnig help (coot.), Fax reception, In the ехт.там mode – Panasonic KX-FP200 User Manual

Page 62: Before reqyestnnig help, Coot.)

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Before reqyestnnig help

(coot.)

Fax reception

PROBLEM

CAUSE & REMEDY

I cannot receive documents

automatically.

oThe receive mode is set to the TEL mode. Set to the TEL/FAX,

FAX (or EXT.TAM) mode.

oThe time to answer the call may be too long. Decrease the number

of rings (see pages 44 and 45).

oThe junk mail prohibitor is set to ON (see page 39).

The recording image is faint.

oThe sender transmitted a faint document. Ask them to transmit a

clearer copy of the document.

oThe thermal head is dirty. Clean it (see page 69).

A blank sheet is ejected after the
received documents are printed out.

oThe receiving reduction rate is not programmed correctly. Program

the proper reduction rate (see page 49).

In the ЕХТ.ТАМ mode

PROBLEM

CAUSE & REMEDY

I cannot receive documents

automatically.

oYour greeting message on the answering machine is too long.

Shorten the message (up to 10 seconds).

©There are too many rings on the answering machine. Set to 1 or 2

rings.

©The silent detection feature is deactivated. Activate this feature

(see page 51).

I cannot receive voice messages.

©Check that the answering machine is turned on and connected to

the facsimile unit properly (see page 22).

©Set the number of rings on the answering machine to 1 or 2.

1 cannot retrieve voice messages
recorded on the answering machine

from a remote location.

©The remote access code on your answering machine is the same

as your remote fax activation code. Set a different number for each

code.

©You did not program your remote TAM activation ID in your

facsimile unit correctly. Program the same code that is
programmed on the answering machine (see page 24).

The greeting message on your
answering machine is interrupted

halfway and the caller cannot leave

a voice message.

©The greeting message has a silent pause longer than 4 seconds.

Re-record the greeting message.

1 pressed the remote access code to

access the answering machine

remotely, but the line was

disconnected.

©The code may include “#” which is used for certain features

provided by a telephone company. Change the code on the
answering machine to another number which does not include

then program the same code into the facsimile unit (see page 24).

Callers complain that their message
is interrupted halfway and they

cannot leave a voice message.

©Advise them not to pause for over 4 seconds while recording their

voice messages.

Callers complain that they cannot
send a document.

©Your answering machine ran out of recording tape. Rewind the

tape to record messages.

©You set the answering machine to give only a greeting message.
©The junk mail prohibitor is set to on (see page 39).

62

For Assistance, Call 1-800-435-7329

Advertising