Panasonic Panafax UF-322 - Manual (Page 34)

No. Parameter
Setting
Number
Setting Comments
18 OP CALL TIMER 1 20 sec. Selecting the length of time that your machine signal (rings) for
an incoming voice call in Fax/Tei Auto Switching mode (see page
58). 2 30 sec.
3 40 sec.
4 50 sec.
19 OGM Length (TAM l/F) 1 1 sec. Setting the OGM length of your TAM from 1 to 60 second. Unit will
not start to detect a SI LENT until the time lapse after detecting a
call in TAM Interface mode.
... ...
60 60 sec.
20 SILENT DET (TAM l/F) 1 Invalid Selecting Silent Detection Mode.
2 Valid
22 SUBSTITUTE RCV 1 Invalid Selecting vWiether or not the machine receives to memory when
recording paper runs out, ink ru nsout or recording paper jammed.
2 Valid
23 RECORDING PAPER
SIZE
1 A4 Setting the recording paper size installed in your machine.
2 Letter
3 Legal
24 PRINT REDUCTION
1 Fixed
Selecting print reduction mode.
Fixed: Reduce document according to setting of Parameter No,
25.
Auto: Reduce document according to the iength of received
documents.
2 Auto
25 REDUCTION RATIO 70 70% Selecting fixed print reduction ratio from 70% to 100%. This
parameter functions when fixed print reduction is selected on fax
parameter no. 24 or when available memory getting low.
... ...
100 100%
26 POLLING PASSWORD (....) Setting a 4-digit password for secured polling.
27 POLLED FILE SAVE 1 Invalid Selecting whether or notthe machine retainsthe polled document
in memory even after the document is polled once.
2 Valid
26 STAMP AT MEM. XMT 1 Invalid Selecting whether or not the machine stamps the original
documents when storing the documents into memory.
2 Valid
32 COPY REDUCTION 1 Invalid Selecting whether or not the machine performs copy reduction in
accordance with the setting of Parameter No. 24 and 25.
2 Valid
33 XMT REDUCTION 1 invalid Selecting whether or not the machine performs reduction when
the transmitting document is widerthan the recording paper used
at the receiving machine.
2 Valid
37 RCV TO MEMORY
(-...)
Enter a 4-digit password used to print out the received document
in memory by F8-5 (RCVTO MEMORY). When F8-5 is set to On,
this parameter will not be shown on the LCD display, (see page
83)
38 FAX ACCESS CODE
(....)
Enter a 4-digit Fax Access Code to secure the machine from
unauthorized use. (see page 82)
41 RELAY XMT REQUEST 1 Invalid Selecting whether or not the machine performs Relay XMT
2 Valid
Reguest, (see page 101)
Continued on the next page.
34