Panasonic KX-F160 - Manual (Page 28)

Setting your logo
The logo is used to identify fax documents sent by your unit. It may consist of alphanumeric
letters and symbols.
Usually the logo is a company, division or personal name in an abbreviated form. Your
programmed logo will be printed on the top of each page transmitted from your unit.
Your printed logo can be up to 30 digits long. “Panasonic ANS/FAX” is stored in your unit as
default.
To enter each character, select the correct code (2 digits) referring to the character code table
(see page 1-21), then program as follows.
HELPFUL HINT:
When you lose your procedures while programming, press the HELP button.
You will be able to print information about how to set.
1
2
3
r~n ED ED
(GHI 4 j sj (
MM3
6 j
[ PRS 7 ] ['»V 8] [w>'<
9
]
[
-X-]
[ tf]
Press the PROGRAM button.
The PROGRAM indicator lights.
Press #, then press 02.
The PROGRAM indicator flashes.
To obtain the character codes, press the HELP button.
Enter your logo by using the dial keypad.
Example; If you want to program the logo as “ABC
Company”, press “30 31 32 01 32 74 72 75
60 73 84”-
The logo can be up to 30 characters long.
When finished, press the SET button to store the
program into memory.
The PROGRAM indicator lights.
The result of your setting is printed out automatically for
confirmation.
If you wish to correct your programming, try again from
step 2.
Press the PROGRAM button to end the operation.
The PROGRAM indicator goes out.
NOTE:
To correct an error while programming, press the STOP/CLEAR button then repeat from step 2.
1-20