Panasonic KX-TG2670N - Manual (Page 53)

Temporary Tone Dialing
(For Rotary or Pulse Service Users)
Press [TONE] before entering access numbers which require tone dialing.
•The dialing mode changes to tone. You can enter numbers to access an
answering service, electronic banking service, etc. When you hang up, the mode
will return to pulse.
•Access numbers entered after pressing [TONE] will not be included when
redialing.
FLASH Button
Pressing IFLASH/CALL WAlT/PLAYBACKl or IFLASH/CALL WAITl allows
you to use special features of your host PBX such as transferring an
extension call or accessing special telephone services (optional) such as
call waiting.
Selecting the flash time
The flash time depends on your telephone exchange or host PBX.
You can select the following flash times: “700, 600, 400, 300, 250, 110,
100 or 90 ms (milliseconds)”. Your phone comes from the factory set to
“700 ms”. Make sure the unit is in the standby mode initially.
1
2
3
Press iFUNCTION/CHl.
Press (5 or ® repeatedly until the arrow points to “Program”, and
press ® (Yes key).
Press ® or ® repeatedly until the arrow
points to “Set flash time”, and press
0 (Yes
key).
Save DIRECT#
►Set flash time
Ti
►=Yes
Press ® or ® repeatedly until the
desired time is displayed, and press ®
(Save key).
•A beep sounds. ____
•To return to the standby mode, press [OFF],
Flash time
:700ms
TA ►=Save
«You can exit the programming mode any time by pressing [OFF],
«If you are connected via a PBX, a longer flash time may be necessary to use
PBX functions (transferring a call etc.). Consult your PBX supplier for the correct
setting.
53