Setting the unit to call a pager – Panasonic KX-TG2670N User Manual

Page 63

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Setting the Unit to Call a Pager

Press

[FLASH/CALL WAIT/PLAYBACK|.

1

•The number of new messages

is heard on the handset.

Press [3).

•“

’’ is displayed on the

base unit.

•If “EE33 ” is not displayed, the

pager number has not been

stored. Store the number

(p. 58, 59), and try again.

Press I

FLASH/CALL WAIT/PLAYBACKl.

To turn off the pager call mode,

repeat steps 1 through 3.

.“[¡2033” wiil disappear,

•Each time you press [3] in step 2, the

mode wili turn on or off.

[FLASH/CALL WAIT/PLAYBACK]

If you have not subscribed to a Caller ID service, the caller’s telephone
number will not be displayed on your pager.

•If another message (or Caller ID cal!) is received before the unit alerts your pager

for a previous message (or Caller ID call), the previous caller information will not

be sent to your pager. Only the last call received will be sent to your pager.

•If someone else makes or answers another call with the unit or a parallel

connected phone before the unit alerts your pager for a previous message (or

Caller ID call), the unit will stop alerting your pager for that message (or Caller ID

call).

•If you receive a telephone number on your pager but cannot recognize the caller,

you may have received a direct inward dial (DID) call, such as from a PBX.

Please call your unit to check the caller’s message.

63

Advertising