Panasonic DMC-FS5 - Manual (Page 83)

Connecting to other equipment
Connectih^f f > , i
You can acquire recorded pictures to a PC by connecting the camera and the PC.
•You can easily print out or mail the pictures you have imported. Use of the
“PHOTOfunSTUDIO-viewer-” bundled software on the CD-ROM (supplied) is a convenient
way of doing this.
Preparations:
Turn on the camera and the PC.
Remove the card before using the pictures in the built-in memory.
Connect the camera to a PC via the USB connection cable
®
(supplied).
® USB connection cable (supplied)
• Check the directions of the connectors, and plug them straight in or unplug them straight out.
(Otherwise the connectors may be bent out of shape which will cause trouble.)
@ Align the marks, and insert.
© AC adaptor (DMW-AC5PP; optional)
• Use a battery with sufficient battery power or the AC adaptor (DMW-AC5PP; optional). If the
remaining battery power becomes low while the camera and the PC are communicating, the
status indicator blinks and the alarm beeps.
Refer to “Disconnecting the USB connection cable safely” (P84) before disconnecting the USB
connection cable. Otherwise, data may be destroyed.
Press A/T to select [PC], and then press [MENU/
SET],
• If [USB MODE] (P24) is set to [PC] in the [SETUP] menu in
advance, the camera will be automatically connected to the PC
without displaying the [USB MODE] selection screen. Since there
is no need to set this each time you connect to the PC, it is
convenient.
• When the camera has been connected to the PC with
[USB MODE] set to [PictBridge(PTP)], a message may appear
on the PC's screen. Select [Cancel] to close the screen, and
disconnect the camera from the PC. Then set [USB MODE] to
[PC] again.
OH USB MODE
fm'pc
SELECTO , , , SET^
VQT1M97
83