Panasonic DMC-FS5 - Manual (Page 96)

[PICTURE IS DISPLAYED FOR 4:3 TV]/[PICTURE IS DISPLAYED FOR 16:9 TV]
•The AV cable is connected to the camera.
^ Press [MENU/SET] if you want to delete this message at once.
^ Select [TV ASPECT] in the [SETUP] menu if you want to change the TV aspect. (P24)
•This message also appears when the USB connection cable is connected to the camera only.
In this case, connect the other end of the USB connection cable to a PC or a printer. (P83, 85)
[PRINTER BUSY]/[PLEASE CHECK THE PRINTER]
•The printer cannot print.
^ Check the printer.
Functions that cannot be set or wi
some conditions
Due to the camera's specifications, it may not be possible to set some of the functions or
some functions may not work in some of the conditions under which the camera is used.
The table below lists these functions and the corresponding conditions.
• For the functions which cannot be set or will not work in the Intelligent auto mode, refer to
“Settings in intelligent auto mode” (P29).
Functions that cannot be set
or will not work
Main conditions in which the functions cannot be set or will not
work
[AUTO POWER LCD]/
[HIGH ANGLE] (P22) •B mode
[POWER SAVE] (P23) •When using the AC adaptor
•When connecting to a PC or a printer
•When recording or playing back motion pictures
•During a slide show
•[AUTO DEMO]
[AUTO LCD OFF] (P23) •When using the AC adaptor
•While the menu screen is displayed
•While the self-timer is set
•While recording motion pictures
•When connecting to a PC or a printer
[AUTO REVIEW] (P23) •O mode
Extended Optical Zoom
(P32) .........
•f^^ and a in [SCENE MODE1]/[SCENE MODE2]
•O mode
[DIGITAL ZOOit/I] (P32) •a. M, M, d, r+'l and a in [SCENE MODE1]/
[SCENE MODE2]
•When [INTELLiGENT iSO] is set
[FLASH] (P39) •When auto bracket has been set
•When the burst mode is established
•H,
m, 2E, a, m, ^ and @ in [SCENE MODE1]/
[SCENE MODE2]
•O mode
[SELFTIMER] (P44) • a and O in [SCENE MODE1]/[SCENE MODE2]
•O mode
96
VQT1M97