Cisco IAD2430 - Manual (Page 53)

3-17
Cisco IAD2430 Series Integrated Access Devices Hardware Installation Guide
OL-4234-06
Chapter 3 Installing Cisco IAD2430 Series IADs
Installing a WAN or Voice Card
Figure 3-16 Chassis Ground Connection Using Ring Terminal
Step 5 Connect the other end of the ground wire to a grounding point at your site.
Installing a WAN or Voice Card
The Cisco IAD2430 series IADs include a slot for a WAN interface card (WIC) or a voice interface card
(VIC).
Note The Cisco IAD2435 router is a fixed-configuration router and does not support interface cards.
The following WICs and VICs (also used by the Cisco 2600 series and Cisco 3600 series routers) are
supported in releases of the Cisco IAD2430 series IADs:
• WIC-1T
• WIC-2T
• WIC-1DSU-T1/E1
• VIC2-2FXS
• VIC2-4FXS
• VIC2-2FXO
• VIC2-4FXO
• VIC2-2BRI-NT/TE
• WIC-1ADSL
• WIC-1SHDSL-V2
• WIC-1ADSL-DG
• VWIC-2MFT-T1/E1
• VWIC-2MFT-E1
Warning For connections outside the building where the equipment is installed, the following ports must be
connected through an approved network termination unit with integral circuit protection.
FXS/T3/E3. Statement 1044
103512
Ring terminal
attachment