Connecting cables – Cisco IAD2430 User Manual
Page 54
3-18
Cisco IAD2430 Series Integrated Access Devices Hardware Installation Guide
OL-4234-06
Chapter 3 Installing Cisco IAD2430 Series IADs
Connecting Cables
Note
Contact your Cisco account representative for the most recent, supported cards.
For detailed information on installing and connecting interface cards, see “Installing WAN and Voice
Interface Cards in Cisco Modular Routers,” in the Cisco Interface Cards Installation Guide, at the
following URL:
Caution
WAN and voice interface cards do not support online insertion and removal (hot swapping). Before
inserting a card into the Cisco IAD chassis, you must turn off electrical power and disconnect network
cables.
Always use an ESD-preventive wrist strap before handling cards.
To install a WIC or VIC, follow these steps:
Step 1
Use a number 2 Phillips screwdriver to remove the screws holding the metal plate over the card slot
cover. Remove the plate.
Step 2
Holding the interface card by the edges, line up the card with the guides on both sides of the slot.
Step 3
Insert the card in the slot. Push until it is firmly seated in the connector and the front panel of the card
is flush with the back panel of the Cisco IAD.
Step 4
Use the screwdriver to tighten the captive screws on the card.
Connecting Cables
Cisco IAD ports are color-coded for identification.
Warning
Do not work on the system or connect or disconnect cables during periods of lightning activity.
Statement 1001]
Warning
This product relies on the building’s installation for short-circuit (overcurrent) protection. Ensure that
the protective device is rated not greater than: 120 VAC, 15A (240 VAC, 10A international) Statement
1005
Warning
To prevent accidental discharge in the event of a power line cross, route on-premise wiring away
from power cables and off-premise wiring, or use a grounded shield to separate the on-premise
wiring from the power cables and off-premise wiring. A power line cross is an event, such as a
lightning strike, that causes a power surge. Off-premise wiring is designed to withstand power line
crosses. On-premise wiring is protected from power line crosses by a device that provides
overcurrent and overvoltage protection. Nevertheless, if the on-premise wiring is in close proximity