Cisco IAD2430 - Manual (Page 33)

2-3
Cisco IAD2430 Series Integrated Access Devices Hardware Installation Guide
OL-4234-06
Chapter 2 Planning Your Installation
Location and Mounting Requirements
Caution The Cisco IAD2430 series chassis provides inputs for both AC and DC power. Design your installation
to use only one type of power. Do not use AC and DC power at the same time. If you do, the unit stops
operating, and you need to reboot it with only a single power source.
If you suspect that your AC power is not clean—for example, if lights flicker often or if there is
machinery with large motors nearby—have a qualified person test the power. Install a power conditioner
if necessary.
Please read all the warnings and cautions before applying power to your Cisco IAD.
Warning Do not work on the system or connect or disconnect cables during periods of lightning activity.
Statement 1001
Warning Read the installation instructions before you connect the system to its power source. Statement 1004
Warning This product relies on the building’s installation for short-circuit (overcurrent) protection. Ensure that
the protective device is rated not greater than: 120 VAC, 15A U.S. (240 VAC, 10A international)
Statement 1005
Warning The device is designed for connection to TN and IT power systems. Statement 1007
Warning This unit is intended for installation in restricted access areas. A restricted access area can be
accessed only through the use of a special tool, lock and key, or other means by security. Statement
1017
Cable Types
The cable types that you use depends on which Cisco 2430 series IAD you are using. For more
information see the
“Interfaces and Service Capabilities” section on page 1-11 .
• Fast Ethernet cables RJ-45-to-RJ-45 straight-through cables
• Analog voice cables (RJ-21)
• T1/E1 interface cable (RJ-48)
• Synchronous serial cables
– EIA/TIA-232 (DCE/DTE)
– EIA/TIA-449 (DCE/DTE)
– V.35 (DCE/DTE)
– X.21 (DCE/DTE)
– EIA/TIA-530/EIA/TIA-530A (DCE/DTE)