Brookfield DV2T Viscometer - Manual (Page 88)

Brookfield Engineering Labs., Inc. Page 88 Manual No. M13-167-B0614
Step 3:
• Completely remove Tab 1 (see Figure K-3).
• Lightly press the screen protector to the touch screen.
• Inspect the alignment of the screen protector. If the screen
protector is touching the bezel (frame), them remove and
reapply.
Step 4:
• Peel back Tab 2 all the way to remove the backing, which
also removes the alignment tool (see Figure K-4). The screen
protector is now in place.
Step 5:
• Use the soft card provided to push trapped air bubbles from
the center of the screen to the edge (see Figure K-5). Small
bubbles should go away within 48 hours.
• DO NOT use the soft card to push the screen protector
under the bezel (frame). If the screen protector is not
properly aligned, remove and reapply. Two screen protectors
are provided in this package in case the first attempt is
unsuccessful.
• Test the viscometer (power on) to ensure that the screen
protector is properly attached. The screen protector is
properly aligned if the DV2T Viscometer responds normally
to a touch on the touch screen. If the DV2T Viscometer is
unresponsive to touch then remove the screen protector
and reapply.
Removal of the Screen Protector
The screen protector should be replaced when it has become dirty. It can be easily
removed from the DV2T Viscometer by hand. The upper right hand corner of the screen
protector has a small angle cut. Use a finger nail or blunt object to pry the screen protector
away from the touch screen and peel it of the touch screen.
Be careful not to scratch the touch screen when removing the screen
protector.
Figure K-3
Figure K-4
Figure K-5