ChemoMetec NC-200 - Manual (Page 13)

991-0204 Rev. 1.1 September 2012 13
3. You will now see a series of pop-up messages from the Windows operating system informing about
driver installations. Among those are:
- A USB hub inside the NucleoCounter® NC-200™ instrument
- FTDI device driver installed
- The camera
Due to the intentional and very fast reconfiguration of the camera, you may see an error message
from Windows, which can just be ignored. Click Close on any of these pop up messages if needed.
When the NucleoView® NC-200™ software detects and has initialized the instrument, the previous
red icon changes to true life colors indicating the instrument has been successfully installed.
4. NucleoView® NC-200™ will display a message box stating successful installation of the instrument,
and recommend that you continue installation of this instrument on the remaining USB ports on
the PC. Click ‘Yes’ to do so.
5. You will then be prompted to unplug the USB cable from the USB port on the PC. Do this and click
‘OK’.