Installation of licenses and protocols, Software upgrade – ChemoMetec NC-200 User Manual
Page 14
991-0204 Rev. 1.1
September 2012
14
6. When NucleoView detects that the instrument has been disconnected, the icon will again turn red,
and you will be prompted to connect the instrument to another USB port on the PC.
7. Repeat the procedure described to install the instrument on the remaining USB ports on the PC.
8. If you are installing more than one instrument on the same PC, you must repeat the USB
installation for all instruments on all USB ports, but note that only one instrument must be
attached at any time.
Installation of Licenses and Protocols
Follow the procedure described in the Licenses section to install licenses and protocols. This is not needed
during a normal installation procedure, as licenses and protocols are installed automatically.
Software Upgrade
New software releases are typically distributed via our web page or on USB sticks and are installed as
described below. Collected data (images), settings and installed licenses will be preserved.
1. IMPORTANT: Log on with administrator rights for this upgrade session.
2. Disconnect any NucleoCounter® NC-200™ instrument connected to the PC.
3. Insert the USB stick holding the software upgrade or download and unpack the software upgrade.
4. Continue as described in the previous section installation of software and the NucleoView® NC-
200™ Install Wizard will now guide you through the remaining part of the upgrade.
Installation of a new NucleoCounter® NC-200™ Instrument
To install one or more new NucleoCounter® NC-200™ instruments, use the USB stick holding the
appropriate NucleoView® NC-200™ software release and follow the procedure in the previous section
describing installation of software. The NucleoView® NC-200™ Install Wizard will guide you through the
remaining part of the upgrade. While following this procedure, you will be given the option to specify which
NucleoCounter® NC-200™ devices you want installed (identified by their serial numbers). Be sure to check
the boxes which specify the new serial number(s) you want installed.