Cub Cadet Medium Frame 3 Stage - Manual (Page 107)

Discharge Chute and Controls (Joystick, Cable Style)
103
6. Remove the six screws that fasten the joystick to the
dash with a 3/8” wrench. See Figure 9.14.
NOTE: Folding the handle bars down will allow easier
access to the joystick assembly.
7. Remove the joystick and its mounting bracket.
8. Install the joystick by following the previous steps in
reverse order.
NOTE: Unwind the cables prior to attaching them to the
snow thrower. Allow the cables to flow without tan-
gling or twisting. Twists or kinks in the cable can
create a bind in the chute directional control.
NOTE: Insure that the double-D on the Remote Head is
properly seated in the Discharge Chute before
installing the shoulder bolt.
9. Test run the snow thrower in a safe area before
returning it to service.
Figure 9.14
Mounting bracket