Cub Cadet Medium Frame 3 Stage - Manual (Page 49)

700 Series 2-Wheel Track-Drive System
45
11. Drive out the old bushings using a drift punch. See
Figure 5.21.
12. Install new bushings in the axle tube.
13. Set the axle tube in place.
14. Slip the chain over the axle tube.
15. Slide the axle into the axle tube.
16. With the teeth of the sprocket gears next to each
other, slip the chain onto both sprockets.
17. Install the two screws that hold the axle tube in place.
18. Install the two nuts, bolts and fender washers that
secure the axle tube to the side plate using a 1/2”
wrench and a 5/8” wrench. See Figure 5.23.
19. Install the rear housing.
20. Install the access panel.
21. Install the Track and Track Wheels by following the
procedure described in the Track and Track Wheel
section of this chapter.
22. Test drive the unit in a safe area before returning it to
service.
Figure 5.21
Figure 5.22
Figure 5.23
Fender washers