Cub Cadet Medium Frame 3 Stage - Manual (Page 99)

Discharge Chute and Controls (Manual Crank)
95
14. Insert a pick or similar tool into the hole in the Gear
Shaft while removing the nut with a 9/16” wrench.
See Figure 8.30.
15. Remove the hex bushings, spring and washers from
the shaft.
To assemble the Remote Head:
1. Slide the Worm Gear onto the Gear Shaft so that the
alignment mark is facing and is aligned with the holes
in the gear shaft.
NOTE: Slide the gear onto the shaft from the side with the
holes.
Figure 8.30
Figure 8.31
Figure 8.32
Alignment Mark
Hole