Cub Cadet Medium Frame 3 Stage - Manual (Page 59)

700 Series 3-Wheel Track-Drive System
55
10. Slide the Rear Wheel off of the Rear Axle. See Figure
6.6.
11. Remove the Rear Wheel.
12. Lift the Track off of the machine.
13. Repeat on the opposite side.
To install the tracks:
1. If the Rear Axle fell out, set the it on the machine so
that the flanges are inside the slots in the Track
Frame. See Figure 6.7.
2. With the idler hold-down tools still in place, set the
Track on the drive wheel and Front Wheel.
NOTE: Make sure the treads on the Tracks are facing the
right direction. See Figure 6.8.
Figure 6.6
Rear Wheel
Figure 6.7
Rear Axle
Flange
Figure 6.8
Front Bottom view