Cisco OL-21636-01 - Manual (Page 103)

C H A P T E R
6-1
Cisco IP Solution Center L2VPN and Carrier Ethernet User Guide, 6.0
OL-21636-01
6
Managing a FlexUNI/EVC ATM-Ethernet
Interworking Service Request
This chapter provides information on how to provision a FlexUNI/EVC ATM-Ethernet Interworking
service request. It contains the following sections:
• Overview, page 6-1
• Creating a FlexUNI/EVC ATM-Ethernet Interworking Service Request, page 6-2
• Setting the Service Request Details, page 6-3
• Modifying the FlexUNI/EVC Service Request, page 6-23
• Using Templates and Data Files with a FlexUNI/EVC Service Request, page 6-24
• Saving the FlexUNI/EVC Service Request, page 6-24
Overview
A FlexUNI/EVC ATM-Ethernet Interworking service request allows you to configure interfaces on an
N-PE to support the FlexUNI/EVC features described in
Chapter 5, “Creating a FlexUNI/EVC
ATM-Ethernet Interworking Policy.” To create a FlexUNI/EVC ATM-Ethernet Interworking service
request, a FlexUNI/EVC ATM-Ethernet Interworking service policy must already be defined, as
described in
Chapter 5, “Creating a FlexUNI/EVC ATM-Ethernet Interworking Policy.” Based on the
predefined FlexUNI/EVC policy, an operator creates a FlexUNI/EVC service request, with or without
modifications to the policy, and deploys the service. One or more templates can also be associated to the
N-PE as part of the service request.
ATM-Ethernet interworking is supported through the following configurations:
• ATM Transport Mode (VC)
– ATM-Ethernet Pseudowire
– ATM-ATM Local connect
– ATM-Ethernet Local connect
• ATM Transport Mode (VP)
– ATM-ATM Local connect
The following steps are involved in creating a FlexUNI/EVC ATM-Ethernet Interworking service
request:
• Choose an existing FlexUNI/EVC ATM-Ethernet Interworking policy.