Setting the flexuni attributes, Figure 5-3 – Cisco OL-21636-01 User Manual

Page 89

Advertising
background image

5-7

Cisco IP Solution Center L2VPN and Carrier Ethernet User Guide, 6.0

OL-21636-01

Chapter 5 Creating a FlexUNI/EVC ATM-Ethernet Interworking Policy

Setting the FlexUNI Attributes

Figure 5-3

EVC Policy Editor - ATM Interface Attributes Window

To set the ATM interface attributes, perform the following steps.

Step 7

Choose the Transport Mode from the drop-down list.

The choices are:

VP—Virtual path mode. This is the default.

VC—Virtual circuit mode.

Step 8

Choose the ATM Encapsulation from the drop-down list.

AAL5SNAP

Step 9

Click Next.

The EVC Policy Editor - FlexUNI Attribute window appears, as shown in

Figure 5-4

.

Step 10

Continue with the steps contained in the next section,

Setting the FlexUNI Attributes, page 5-7

.

Setting the FlexUNI Attributes

This section describes how to set the FlexUNI attributes for the FlexUNI/EVC ATM-Ethernet
Interworking policy, as shown in

Figure 5-4

.

Advertising