Freerider FR510GDX(D,Land Ranger XL8) - Manual (Page 13)

24 25
bottom right of your console, the direction indicator
lights for right and left maneuvers are controlled by
this switch. When making a turning maneuver on
the road the appropriate switch direction should be
made. Simply, when turning right ‘flick’ the switch to
the right, you will note a warning ‘bleeper’ is audible
and the appropriate direction warning lightwill flash.
To cancel the direction indicator return the switch to
the centre position. The left direction indicators are
activated by ‘flicking’ the switch to the left. Caution:
Please note the direction indicators are not self-
canceling.
Warning: Please be aware to test the function of
your direction lights before each journey. Failure to
observe this warning could put you and other road
users into a dangerous situation. If in the event a
direction indicator
bulb fails, you will note the direction warning light
on your console flashing quicker than normal, in this
situation the appropriate bulb should be substituted.
Status Bar Gauge detects 9 similar fault diagnostic
signals, reference to these diagnostic codes is found
under ‘fault finding’ on page 25.
3.Distance/ Temperature/ Time indicator :
Will illuminate when power On and they also exhibit
in different value.
4. Direction Indicator Light Switch: Located at the
valuable battery power. Your FR 510-GDX Scooter will
automatically go into a sleep mode to preserve battery
energy after approximately 15 minutes. To start your
Scooter again simply switch the key to ‘off ’ and back to
‘on’ again, your Scooter is now ready to go.
2. Battery Gauge/Status Indicator Light: Located at the
top of your console. This is a 10 bar segmented
colour illuminated display which indicates when your
Scooter is switched on, it also displays the status of
the batteries, the speed controller and the Scooter’s
electrical system.
‘Battery Gauge’: When your Scooter is switched on,
after half a second, the colored bars will illuminate to
show the level of charge in your batteries. If the battery
gauge displays red, yellow and green your batteries are
fully charged and you are ready to drive. As the power
is used up in your batteries the bar indication will move
towards the red sector indicating the state of charge at
that precise time.
If the battery gauge displays red and yellow, then your
batteries have lost charge and they should be recharged
as soon as you can, but you will still have power to spare.
When the battery gauge falls into the red sector, either
steady or flashing slowly, then you should recharge your
batteries without delay.
It is not recommended to drive your Scooter regularly
with the battery charge indication in the yellow to red
sector, as this will shorten battery life. It is wise to re-
charge your batteries after each journey especially as it
enters the yellow to red sectors of your battery gauge (see
Batteries and Battery Charging section of this
manual) Note: When driving up steep slopes or similar
obstacles your FR 510-GDX’s motor will be working
hard, the battery gauge may move towards the red
sector, it will recover towards the green sector once the
load on your motor is reduced, this does not indicate
low batteries.
‘Status Warning Indicator’: When you turn your
FR 510-GDX Scooter on, after half a second the
battery bar gauge will illuminate at a constant rate
indicating the state of charge level in your batteries. The
battery bar gauge is connected to a very sophisticated
diagnostic system which can identify faults should they
occur on the main speed control system or some other
part of your Scooter’s electronic drive system. If in the
unlikely event a fault should occur with your FR 510-
GDX Scooter you can find out what has happened by
counting the number of bars that are flashing on the
battery gauge. For instance if your batteries run low on
power, the status indication will flash slowly one bar,
indicating that the batteries need recharging or that
there is a poor connection to the batteries. The Battery
Flash Description Meaning
1 Battery Low
2
3
4
5
6
7
8
9
Low Battery Fault
The batteries are running low. Recharge the batteries.
The batteries have run out of charge. Recharge the batteries.
Check the battery and associatedconnections and wiring.
High Battery Fault
Current Limit Time-out or
Controller too hot
Park Brake Fault
Drive Inhibit
Speed Pot Fault
Motor Voltage Fault
Other error
Note:
The Low Battery Fault Flash code, described above, is a requirement of various safety standards.
The scooter will output a visible and audible low battery warning if the battery voltage drops below
90% of its cut-off voltage. The warning will be two short flashes, and will
take priority over all
other flash codes in the system.
Battery voltage is too high. This may occur if overcharged
&/or travelling down a long slope.
If travelling down a slope, reduce your speed to minimize
the amount of regenerative charging.
The motor has been exceeding its maximum current rating
for too long.
The scooter may have stalled. Turn the controller off, leave
for a few minutes and turn back on again.
The motor may be faulty. Check the motor and associated
connections and wiring.
Either a park brake release switch is active or the park brake
is faulty. Check the park brake and associated connections
and wiring. Ensure any associated switches are in their
correct positions.
Either a Stop function is active or a Charger Inhibit or
OONAPU condition has occurred. Release the Stop
condition (seat raised etc.) Disconnect the Battery Charger
Ensure the throttle is in neutral when turning the controller
on. The Throttle may require re-calibration.
The throttle, speed limit pot, SRW or their associated wiring
may be faulty. Check the throttle and speed pot and
associated connections and wiring.
The motor or its associated wiring is faulty. Check the motor
and associated connections and wiring.
The controller may have an internal fault. Check all
connections and wiring.
FR510GDX Flash Codes
5.Status light::The green light will illuminate at aconstant
rate when Key switch on and will flash for identify
faults.
6. Hi/Lo Speed Switch: Located on the left side of your
console this switch controls the maximum high (Hi)
and low (Lo) speed range for your FR 510-GDX
Scooter. When riding on the pavement or in shopping
areas the low 4mph speed range must be engaged,
this is a legal requirement and must be adhered to at
all times.
When the low speed range is chosen a ‘red’ warning
light will illuminate. The Hi/Lo speed range switch
can be operated while the Scooter is in motion.
Please note the Hi/Lo speed switch works in conjunction
with the speed adjustment dial and the forward/reverse
speed lever; the speed dial must be set to it’s highest
setting for maximum speed in both Hi and Lo speed
settings.
7.Temperatures : Switch between Centigrade and
Fahrenheit.
1. Short press for switching between Centigrade and
Fahrenheit.