Technical specification – Freerider FR510GDX(D,Land Ranger XL8) User Manual

Page 18

Advertising
background image

34

35

specific, due to other factors such as; motor loads, tyre

pressures, general service factors, working conditions,

periods of non-use and abuse etc.

When you need to purchase batteries, always insist on

the model fitted as original equipment to your FR 510-

GDX. Do not use less expensive car starter batteries. If

in doubt, consult your local Freerider authorized agent.

Warning: Correct disposal of exhausted batteries is

advised.

Please note: The charger supplied with your Freerider

Scooter is specifically designed for sealed type batteries

and may not work correctly with other battery designs.

(See also Batteries and Battery Charging section of this

manual).

LUBRICATION

The Freerider FR 510-GDX has been designed with

low maintenance in mind. Wheel bearings and steering

bearings are sealed for life. The following points will

need checking/lubricating at the following service

intervals:

RECOMMENDED SERVICE INTERVALS

DAILY Check the following:

Operation of motor brake

Operation of driving brake

Operation of manual emergency brake

Operation of seat lock (

see page 27

)

Tire condition

Batteries are fully charged

Operation of driving lights and turning indicators

Caution:

Only drive your FR 510-GDX Scooter if

it is in full working order.

WEEKLY Check the following and adjust as necessary:

Arm rest tightening knobs (

see page 28

)

Tire pressures

Battery fastening strap (

see page 31

)

Allow battery charger to go through a full recharge

cycle until the green light is illuminated

Clean paintwork with auto shampoo. Do not use a

high pressure hose. Wax painted and bright metal parts.

SIX MONTHS

Check and adjust as necessary:

Tire wear, replace as necessary

(minimum tread 0.5mm)

All fasteners and fittings for sound function.

Tension of handle bar lock and hinge bolt.

Battery connections.

Inspect all electrical plugs and sockets for damage

and good contact and fit.

Lubricate the following:

Speed accelerator lever pivot point (

see Fig 25

)

Spray metal parts with moisture repellent (WD40)

Seat lock lever pivot bolt

Seat arm hinges

Inspect, lubricate and adjust upper handle bar

steering bearings with grease

ANNUALLY

Check the following and adjust as necessary:

Motor carbon brush wear

(minimum brush length 8mm)

Front wheel bearings for wear

Chassis for sound welds

Rear Drive wheel hub key

All wheel bolts

Drive axle securing nuts

Motor mounting bolts

Magnetic motor brake disc and function

Manual brake shoe lining wear

Main control box electrical connections

Main wiring loom for damage

All steering components

Clean chassis and repaint any exposed parts

Lubricate on/off power key barrel with light oil

Replace any damaged axle seals

Cycle test charger for full operation function

Cycle test batteries for operating capacity

(This test can be performed by your Freerider Agent)

LUBRICATION

Use a general purpose light lubricating oil on moving

parts. All wheel bearings are factory sealed and should

not normally need lubricating.

Your drive axle is factory filled with a special lubricant

and will not normally need replacing.

Caution:

Do not mix other lubricants with this

factory fitted drive axle lubricant. Failure to observe this

caution will invalidate your guarantee.

Please note: These service intervals are a guide, more

frequent use of your Scooter may require adjustment to

these suggested intervals.

FIG 25

TECHNICAL SPECIFICATION

Dimensions

cm

inch

Total Length

152

60

Maximum width over wheels

74

29

Turning Diameter (between walls)

125.5

49.5

Maximum seat height from base

49

19.5

12.5

Minimum seat height from base

46

18

Maximum seat height from ground

76

30

Seat backrest angle (adjustable)

90° to 105°

Seat fore-aft sliding adjustment

8

3

Minimum seat width (arms adjustable)

48

19

Seat depth

49

19

Backrest height (without extension)

46

18

Maximum Handlebar height from ground

(adjustable)

74

29

Minimum handlebar height from ground

(folded for transportation)

46

18

Ground clearance

8.8

3.5

Front Wheel size

31

Rear Wheel size

35

14

Weights

Kg

190 Kgs / 220 Lbs / 30 stones

Lbs

Total weight including batteries

107.5

237

Frame Assembly (heaviest part)

87

192

Seat

18

39

Battery (each)

32

70

Charger

9

20

Maximum user weight

Advertising