KEYENCE OP-87305 - Manual

Copyright (c) 2010 KEYENCE CORPORATION. All rights reserved.
11512E 1041-3 96M11512 Printed in Japan
Connector for connecting the sensor head
OP-87305
Assembly Manual
Read this manual before using the product in order to achieve maximum performance.
Keep this manual in a safe place after reading it so that it can be used at any time.
„ Symbols
The following symbols alert you to important messages. Be sure to read these
messages carefully.
„ How to assemble the connector
1
Release the tabs on the
connector hood and pull out
the connector in the direction
of the arrow.
(The LV Series does not have
the connector hood)
2
Hold the IDC connector so that
the back side (side where the
wires can be seen) is facing
forward. Push the upper tab in
the direction of arrow (1) and
then open the back side in the
direction of arrow (2).
3
Cut the cables to the appropriate length, and manipulate the end of the
cables as shown in the figure below.
• Peel back the insulation 20 mm from the end.
• Cut the copper shielded wire at its root. (Cut the white string likewise.)
• Twist the silver shielded wire about five times so it does not ravel, and
bend it 90° to the side.
4
Insert the core wires to the very end of the connector hole of the
matching sticker color, and bend the silver shielded wires while pulling
each one of them along the grooves in the direction of the arrow.
5
Close the connector to crimp with a tool such as a parallel plier
(commercially available).
6
Close the upper tab to lock the cables, and then trim off the wires
sticking out of the connector by using a nipper or the like.
7
Firmly insert the connector
into the connector hood.
(The LV Series does not
have the connector hood.)
It indicates a situation which, if not avoided, could result in
product damage as well as property damage.
It indicates tips for better understanding or useful information.
When the cable length of the sensor head is changed, be sure
to connect the amplifier to check that it operates correctly.
NOTICE
Reference
NOTICE
Tab
Connector hood
Connector
Tab
(1)
(2)
Copper shield Silver shield
Silver
Purple
Pink
White
Black
Silver
• lFor re-installation of the connector, limit it to 2 times. If it
is done more than 2 times, use the special OP-87305.
• As opposed to the OP-87305 or the
OP-66850, it is not necessary to use the
connector crimping tool.
If it is used in error, it may cause a
break in the wiring so do not use the
connector crimping tool.
The OP-87305 and the OP-66850 can distinguished in the fashions
below.
OP-87305 OP-66850
NOTICE
Tab
Connector hood
Connector
Tab
Reference
K
N
The symbols K and N
are written
R
T
The symbols R and T
are written
96M11512