A&D Weighing FX-3000i - Manual (Page 65)

63
Display Error code Description
EC, E00 Communications error
A protocol error occurred in communications.
Confirm the format, baud rate and parity.
EC, E01 Undefined command error
An undefined command was received.
Confirm the command.
EC, E02 Not ready
A received command can not be processed.
e.g. The balance received a Q command, but not in the
weighing mode.
e.g. The balance received a Q command while
processing a RE-ZERO command.
Adjust the delay time to transmit a command.
EC, E03 Timeout error
If the timeout parameter is set to “t-Up1”, the balance
did not receive the next character of a command within
the time limit of one second.
Confirm the communication.
EC, E04 Excess characters error
The balance received excessive characters in a
command.
Confirm the command.
EC, E06 Format error
A command includes incorrect data.
e.g. The data is numerically incorrect.
Confirm the command.
EC, E07 Parameter setting error
The received data exceeds the range that the balance
can accept.
Confirm the parameter range of the command.
Other errors If the errors described above can not be released or
other errors are displayed, contact the local A&D dealer.
17-3 Asking For Repair
If the balance needs service or repair, contact the local A&D dealer.
The balance is a precision instrument. Use much care when handling the balance and observe
the following when transporting the balance.
Use the original packing material.
Remove the weighing pan from the main unit