A&D Weighing SE-150KAL - Manual (Page 11)

9
SE-KAL / KAM series
1. Remove the weighing pan from the
base.
2. Remove the 4 screws from the lower
part of the display pole.
3. Insert the display pole under the base
while pulling out the cable into the base
and align the cable opening positions of
the pole and the base. (See “3” in the
illustration.)
‰ Do not pull the cable forcibly.
Take care not to pinch the cable
between the pole and the base.
4. Align the screw holes of the pole and
the base. Using the 4 screws removed
at step 2 to secure the display pole to
the base firmly.
5. Turn the display knob counterclockwise
to remove the display from the display
pole. (“5” in the illustration)
6. Pull the excess cable, from inside the
base, out of the display pole. (See “6”
in the illustration.)
‰ Take care not to damage the cable.
And make sure the cable has no
slack.
7. Put the bundle of cable back into the
display pole.
(See “7” in the illustration.)
8. Place the display on the pole and
secure it using the display knob. (See
“8” in the illustration.)
9. Place the weighing pan on the base.
Base, seen
from above
4
3. Insert
3. Pull out the cable
Base
Display
pole
Cable
Cable
5
5
6
Display
Display knob
8
Bundle
8
7
8
7
Lower part of
the display pole
2