A&D Weighing SE-150KAL - Manual (Page 12)

10
5-2. Installing the scale
1. Select the place for installing the scale. Refer to “Precautions on installing the
scale” below.
2. Adjust the level of the base, using the
spirit level and leveling feet. Confirm
that the bubble is in the center of the
level.
The SE-KAM series has an extra foot at
the bottom of the display pole. Adjust
this foot to touch the floor after adjusting
the level of the base.
3. Press in on the display knob located at the
lower part of the display to tilt the display to an
appropriate angle, 0
°, 30° or 60° .
Precautions on installing the scale
Consider the following conditions to get the most out of the scale.
‰ Install the scale where the temperature and relative humidity are stable and
where there is no draft or vibration.
‰ Installing the scale or storing it for an extended period where the temperature
and relative humidity are high and where there may be abrupt changes in
temperature may cause scale failure.
‰ Install the scale on a solid and level surface.
‰ Do not install the scale in direct sunlight.
‰ Do not install the scale near heaters or air conditioners.
‰ Do not install the scale where flammable or corrosive gas is present.
‰ Do not install the scale near equipment which produces magnetic fields.
‰ Do not install the scale where there is apt to be static electricity, in a place
where the relative humidity is lower than 45% RH. Insulators such as plastic
are apt to be charged with static electricity.
‰ When the scale is installed for the first time, or the scale has been moved,
perform calibration as described in “9. CALIBRATION”.
Leveling foot
Spirit level
The size and shape
depends on the scale model.
0
60
30
Display knob
Display