Functions, 1. setting the parameters – A&D Weighing SE-150KAL User Manual
Page 22
20
10. FUNCTIONS
The scale has function settings to specify the scale performance.
The parameters set in the function settings are maintained even if the power is turned
OFF.
10-1. Setting the parameters
1. Turn the power OFF.
2. Press and hold the TARE switch and press the
ON/OFF switch to turn the power ON. The software
version is displayed.
“
∗∗∗” indicates the software version number.
3. Press the UNITS switch to display the item.
4. Change the item or parameter using the following switches.
UNITS To display the next item.
PRINT To increase the value of the blinking
digit by one (to change the parameter).
When the parameter is changed,
the STABLE indicator turns off.
5. Press the TARE switch to store the setting value.
After “
end
”, the scale returns to the weighing mode.
To restore the function settings to the factory
setting values
When “
Clrfno
” is displayed, press the PRINT switch to
change to “
Clrfgo
”. Then, press the TARE switch. The
function settings are restored to the factory setting values.
After “
end
”, the scale returns to the weighing mode.
Item
Parameter
While
holding down, press
Press
Press
Press
When changed
ON/OFF
Press
Press