A&D Weighing SE-150KAL - Manual (Page 21)

19
9-3. Restoring to the factory setting values
If the gravity acceleration value or calibration weight value is changed unintentionally,
restore those values to the factory setting values, as follows.
‰
Make sure that the scale is in the weighing
mode (displaying “kg”, “lb”, “oz” or “pcs”).
1. Press and hold the TARE switch until
the gravity acceleration value appears,
and release the switch.
2. Press the UNITS switch twice and
display “ ClrC ” .
.
3. Press and hold the UNITS switch until
“
ClrCno
” appears blinking.
4. Press the PRINT switch.
“
ClrCno
” changes to “
ClrCgo
”.
5. When “
ClrCgo
” is displayed, press the
TARE switch. The factory setting
values are restored and “
end
” is
displayed.
To finish the restoring procedure, turn the
power OFF.
Press and hold
(more than 4 seconds)
Release
Press twice
Press
Press and hold
Press