A&D Weighing AD-4407 - Manual (Page 15)

AD-4407 Weighing Indicator Page 13
Single Range
Select resolution and decimal point position and format.
Specify the weighing capacity.
Dual Range
<First range> Select the resolution, decimal point position and format.
<First range> Select the weighing range
<Second range> Select the resolution
<Second Range> Specify the weighing capacity
For the range function, refer to “5.3. Weighing Range Function”.
Specifying the Range and Unit Specifying the Range and Unit Specifying the Range and Unit Specifying the Range and Unit
Step 1 The range and unit of measure are displayed.
Range display : 5ingl : single range
dUal : dual range
To change the range function, use the CLEAR key
Unit display: The active unit is displayed. The unit can be changed such as
kg or lb. The calibration is performed with displayed unit.
Press the MODE key to select a unit and to select a unit for calibration,
use the +/- key. The unit for calibration (first unit) is displayed and the
alternate unit (second unit) is blinking.
ENTER The key to store the data displayed and proceed to the next step.
ESC The key to proceed to the next step without changing them.
Specifying the Resolution, Decimal Point Position an Specifying the Resolution, Decimal Point Position an Specifying the Resolution, Decimal Point Position an Specifying the Resolution, Decimal Point Position and Format d Format d Format d Format
Step 2 The resolution will be displayed as d 0.1 with decimal point. The indicator displays
triangle 1 and the first unit selected at the previous step. Specify the position of
the decimal point with the MODE key. Specify the display format (point or comma)
with the +/- key. Specify the resolution with CLEAR key. The decimal point format
is specified in step. The decimal point format for serial data output is selected
using the F-function settings. Press the ENTER key to store them and proceed to
the next step. When pressing the ESC key, regardless of what is displayed, the
indicator will proceed to the next step without changing them.
5.2. Calibration Procedure